Over 12,000 Airstream Parts Available

 
  • Jacks  with stand handle and foot pads for 23' and bigger Airstream (set of 4)

Can be sold as a individual jack.


INSTALLATION
 
Tools required: hammer, center punch, drill motor, 13/64" diameter drill bit, 3/8" socket and ratchet.
 
NOTE: Park trailer on level ground . Prevent wheels from rolling by using tire chocks, landing gear, or tongue jack.
 
 
STEP 1. Remove stabilizers from package. Crank stabilizers open and slide them under the trailer frame at determined locations. Crank open so stabilizers contact the trailer frame and stabilizers support themselves
 
STEP 2. For each stabilizer place the front (wide) mounting plate flush with the outer surface of the trailer frame. Position the rear (narrow) mounting plate against the crossmember so one of the mounting holes lines up with the crossmember. Crank the stabilizer open until it is secure against the ground and frame
 
 
STEP 3. With the stabilizers in the desired locations, use the mounting plates as a template. Mark the mounting hole locations on the trailer frame with a center punch. Remove stabilizers. Drill (3 each) 13/64" holes in the trailer frame, two at the wide mounting plate location and one in the crossmember for the narrow mounting plate for each stabilizer 
 
STEP 4. Reposition the stabilizers and mount to the trailer frame using the 3/8" socket and ratchet with the self threading screws and lock washers 
 
STEP 5. Make sure stabilizers are cranked up before moving trailer.
 
 
OPERATION
 
STEP 1. Park Airstream on level ground, prevent wheels from rolling by using tire chocks.
 
STEP 2. Level trailer fore and aft using tongue jack or landing gear.
 
STEP 3. Check level gauge for low side of trailer, crank down stabilizers on low side first, brining the trailer to a fine level position.
 
STEP 4. Crank down stabilizers on opposite side of trailer to insure maximum stability. Then re-snug stabilizers on low side of trailer if necessary.
 
NOTE - BEFORE MOVING TRAILER: Crank up stabilizers to fully closed position and tighten 1/4 turn to secure in travel position (this prevents stabilizers from working open due to road vibration).
 
MAINTENANCE: Use small amounts of WD-40 or similar lubricant on drive screw threads and bolt locations as required.

Write a review

Note: HTML is not translated!
    Bad           Good

Jacks with stand handle and foot pads for 23' and bigger Airstream (set of 4)

  • Brand: Airstream
  • Product Code: 400093
  • Availability: In Stock
  • $494.00


Related Products

FOOT PADS-STABILIZER JACK (SET 4)

FOOT PADS-STABILIZER JACK (SET 4)

This part is replacement pads for Part # 400093-01. Set of four 6 inch diameter pads fo..

$39.74

 Jack stabilizer Manual 23' and Larger Airstream Trailers

Jack stabilizer Manual 23' and Larger Airstream Trailers

Jack stabilizer for Airstream trailers. Your Airstream comes with four of these jacks stabilize..

$123.50

Crank For Stabilizer # 400093-01 Airstream Jack

Crank For Stabilizer # 400093-01 Airstream Jack

Fit any 23' and up Airstream with BAL jack system..

$21.55